2/19/2023 0 Comments Sio2 tio2 core shellSynergy (TES), a framework for engineering mutually beneficial relationships between technological and ecological systems, as an approach to augment the sustainability of solar energy across a diverse suite of recipient environments, including land, food, The strategic engineering of solar energy technologies-from individual rooftop modules to large solar energy power plants-can confer significant synergistic outcomes across industrial and ecological boundaries. This phase separation has to be prevented in future work in order to achieve stable performance with the studied storage design. Moreover, it is shown that phase separation in the storage can be reversed by increasing the PCM temperature and mechanical mixing of the liquid phase. It was found that T-History measurements alone are not able to predict this behavior. Instead, the phase separation is likely to occur due to a segregation of different liquid phases across the height of the storage. It is likely that the PCM itself does not suffer from incongruent melting. The results were repeatable and are consistent with T-History measurements of samples from the PCM TES before and after cycling. With later cycles only the bottom part stores latent heat, while the top and middle parts of the storage remain liquid. Both phenomena lead to a gradual decrease of the effective storage capacity. It was found that the PCM TES design exhibits phase separation and increased supercooling with continuous cycling. The storage was charged and discharged with subsequent cycles at different mass flow rates over a fixed temperature range and duration. In this work a commercial storage design for storing cold thermal energy has been studied using a laboratory prototype containing 168 kg of a commercial salt-hydrate phase change material (PCM). Latent heat storage technologies offer process benefits like daily peak shaving. We will continue to study these factors in the future. However, the stirring method, time, and experimental reaction temperature also affected the properties of the material, which was not studied in this experiment. The MPCMs had good performance in terms of thermal properties and heat storage when using 0.40% SDS as an emulsifier, 10 min ultrasonic, a 3.5 pH value, and a 1:1 core–shell ratio. Its surface was uniform and smooth without cracks, and the TiO2 was well dispersed around the docosane, completely coating the docosane without impurities. The results showed that the MPCMs prepared in this paper had a particle size of 2–5 μm and were spherical. In addition, to obtain the optimized formula of the microcapsules, single-factor analysis on the emulsifier type, its mass fraction, ultrasonic oscillation time, pH, and core–shell ratio were performed. The properties of the new material were examined including the microstructure, the chemical elements on the surface of the microcapsules, and thermal conductivity. Its phase transition temperature was approximately 40 ☌, and it can be used as a phase change material (PCM) in a low-temperature solar heat collection system. In this paper, a new type of microencapsulated phase change materials (MPCMs) with docosane as the core and titanium dioxide (TiO2) as the shell was prepared by in situ polymerization.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |